Note

This page explains the MQTT setup of the Tasmota firmware and how to configure the pulse inputs of the e.station. If you do not want to send the data to the nD-enerserve portal, you must enter your own parameters under MQTT. 
MQTT setup
e.station Tasmota MQTT parameters: host, port, client, user, topic and full topic

The e.station comes preconfigured with the access credentials for the nD-enerserve portal.
Normally, you do not need to change any settings here.
If you have accidentally deleted these credentials, you can re-enter them here.
The access credentials for the portal consist of the serial number and a password. You will find these on the large stickers supplied with the device. Please keep the password in a safe place.

The parameters:

  • Host: Enter the address of the MQTT broker here
    nD-enerserve portal: 2.mqtt.enerserve.eu
  • Port: This is the port of the MQTT broker
    nD-enerserve portal: 5553
  • Client: Enter the client name here
    nD-enerserve portal: e.station_
  • User: This is the user name for the MQTT broker.
    nD-enerserve portal:
  • Password: This is the password for the MQTT broker.
    nD-enerserve portal:
  • Topic: The e.station sends its data under this topic.
    Example: 
    tele/estation/EST260500004/SENSOR
    tele/estation/EST260500003/INFO1
    nD-enerserve portal: estation/

After saving, the e.station restarts and starts sending data.

Configuring the meter inputs
Tasmota PV-Station Parameters: pulse inputs meter 1 to 12 in pulses per kWh

You can configure the meters under the menu item
Configuration → e.station (PV-Station)
of the web interface.
Here you can set the number of pulses for each meter input.